58 24K metal oval beads
Creoles
BO ball studs
From the fine 24K chain
4mm cabochons and connector supports
Glue
Square pendants and small shuttles and diamonds
Oval rings

To begin, cut all the chains following the cutting plan below. (see bottom of the tutorial)

Tip: To help you cut the chains symmetrically, place the chain flat in front of a ruler. Then locate the link to be removed, at the measurement level. Then grab this link with the cutting pliers, lift the chain, naturally the chains will fall down, you will thus have the cutting mark for the 2nd piece of chain. Cut in the right place.

Thread 7 beads onto the hoop, then the 2 pieces of chain (the one hanging on the outside and the one that will make the curve under the hoop).

To guide you, do not hesitate to look at the photo below.

Next, thread 15 beads and the chain of the curve. Now thread the other pendant chain.

Place the remaining 7 beads to finish around the creole.

Thread the stem of the hoop earring into its holder, then bend the end upwards with flat pliers to block the stem.

Now place the different decorative elements on the chains with oval rings.

Finally, open the loop under the earring and then put on the square pendant and the hoop. Close the ring.

Make the 2nd loop in symmetry...

Find below the measurements of the chains:

And there you have it! Beautiful creation!