This creation is very easy to make, here we chose to thread the beads on Linhasita thread for the large choice of colors that can be matched to the stones, for its solidity and the ease of tying it to the clasp.

Cut a Linhasita thread of about 60cm and then burn the end of the thread to prevent it from unraveling. This also makes it easier to thread the beads.

Assemble the clasp by making a double knot with the thread on the clasp ring. Cut the excess thread and burn it to stop cleanly.

Thread the beads, punctuating the assembly with golden round beads. Once in the center, thread the pendant directly onto the wire. As its rings are placed in the right direction, you can mount it directly onto the wire without adding any hooks.

Start again in symmetry with the rest of the beads.

Here we made a 40cm choker necklace so that the pendant falls into the hollow of the neck.

Finally, place the other part of the clasp (extension chain or lobster clasp) by making a knot at the edge of the beads.

To make assembly easier, insert a needle into the edge of the beads and tie the knot around the needle. Remove it at the last moment. Your knot is now perfectly placed in the right place!

Place the setting in the center of the pendant.

Your jewel is finished!

Beautiful creation!