For this type of bracelet you have the choice between several assembly techniques. In elastic version and without clasp for ease of assembly and comfort to wear. With a magnetic clasp to be able to put it on and take it off easily. Or in macramé sliding knot version and/or more elaborate with square knots between the beads!

For the elastic version, nothing could be simpler! Thread the beads then make a first simple knot. For the second knot, go through the loop twice before tightening the knot well. You can add a small dab of glue to the knot to consolidate it.

For the magnetic clasp version, here you can use either linhasita thread, or silk or nylon thread. Make a double knot with one end of the thread on the ring of the clasp.

Then thread a metal bead then your natural pearls.

Thread a metal bead again then tie a knot on the other ring of the clasp.

Be careful not to tighten the wire too much, the assembly must remain flexible for comfort.

For the macrame version, choose your thread, paying attention to the thickness of the thread in relation to the hole of the beads and the desired result.

Tie a knot on the wire about 15cm from the end to block the threading of beads.

Thread the beads, here you will put fewer beads than the circumference of your wrist to leave room for the knot.

At the edge of the pearl thread, tie a knot to block them.

Now make a macrame sliding knot. Find the clasp technique here

For the version with knots between the pearls, the knots will be identical to those above. Thread the beads onto the wire as before, leaving the beads free on the wire, then with a new wire of about 50cm make 2 square knots above the first bead (these are the same as for the sliding knot above).

Bring the second bead up under the knot then bring the threads around the bead to make 2 knots under it.

Continue to the end then make a sliding knot to close the bracelet.

And there you have it! Beautiful creations ;-)