0.7mm rigid brass wire
4mm and 6mm cushion beads
Of the  2mm cube beads
A pair of round-nose pliers
A flat pliers

To start, measure your wrist and adjust the details below  to your size. Here we are starting with a 17cm wrist.

These bracelets should not be too tight on the wrist, they should have a loose fit. This way the bangles will mix, the pearls will move and create movement.

Hold the brass wire with the round-end pliers about 2cm from the end. Position the round-end pliers at the point that will correspond to a loop of about 5/6mm in diameter. In fact, your pliers are thinner at the end and widen as you move your sleeves. You will adjust the position according to the size of the desired loop.

Fold the wire around the pliers to form a loop, then hold the end of the wire with the flat nose pliers and wrap the wire around the bottom of the loop once.

Cut off the excess flush.

Be careful to hold your pliers gently, too much pressure will tend to mark the wire!

Then thread the metal beads and cushion...

Measure the brass wire and cut 3cm from your wrist measurement.

At the end of the wire, fold the wire 1cm from the edge to double it. Be sure to fold it well so that it is perfectly against the wire of the bracelet.

Then, using the round-nose pliers, form a hook with the doubled wires. (Look carefully at the photo below to follow the path of the wire).

Lightly shape the wires to give them the shape of the wrist.

Make as many bracelets as you want... for a nice effect you can accumulate 5 or more!!!!

And there you have it! Beautiful creation!