Pearls  4mm mother-of-pearl
Of the  mother-of-pearl mounted pearls
6x8mm mother-of-pearl cabochons
Earrings for 6x8mm cabochons
Of the  3mm and 4mm rings
0.7mm soft brass wire
UHU glue
Pliers for jewelry creations

To start, cut a piece of brass wire about 25cm long.

Divide the 4mm mother-of-pearl bead strand into 2, setting aside half for the other earring.

At one end of the brass wire, form a small coiled loop as shown in the photo below.

Then thread 25 beads onto the brass wire.

Count 9 beads from the wrapped loop and then form a loop with the remaining 16 beads to create the knot loop.

Then twist the loop at the wire crossing to block it.

Now form a ring at the edge of the loop. This will serve as a hook for the earring holder.

Thread 16 beads onto the wire again and then form the 2nd loop in symmetry.

Twisted the loop at the crossing.

Now thread the remaining 9 beads and bring them up to the edge of the loop.

To block the beads, form a small rolled loop as at the start of the assembly.

This gives you a beautiful knot pendant. Give it a nice shape and life by creating curves and rounding the pearl loops.

Then, open a 4mm ring and insert 5 small mounted beads, connect the ring to one of the loops created then close it correctly.

Do the same for the other loop.

Finally, glue the cabochons into the earring holders.

Then connect the BO supports with a 3mm ring on the top of the knot pendant.

Do the same for the other earring.

And there you have it! Beautiful creation!