This creation is very easy to make, you can adapt the number of natural stone beads to your taste. Play with close shades or play with contrasts and/or benefits!

To start, cut a flexible brass wire of about 10/15cm. Length to be adjusted according to the number of beads chosen. For a beautiful result on the wrist, do not exceed 4cm, the length of the chains would become disproportionate.

At one end of the wire, form a loop then place the chain, then wrap the wire around 2 turns at the base of the loop. Cut the excess wire flush. For a delicate and clean result, form a fairly thin loop.

We will cut the chain afterwards, once the pearl assembly is done, to know the exact size of the bracelet.

Start stringing the beads. Play with alternating metal beads to add rhythm. In the center place the 6mm cushion bead then start again in symmetry.

Now calculate the measurement of the bead string.

Measure your wrist then subtract the threading value from your measurement. Divide the result by 2. This gives you the value of the 2 chains to cut. Here we do not add an ease measurement because the clasp and the fastener will add a little weight to the bracelet. If you want a bracelet stuck on the wrist, adjust the measurements a little.

Then, once your 2 chains are adjusted, form a loop 1mm from the last bead. Thread the 2nd chain into the loop then wrap the brass wire around the edge of the loop 2 times then cut the wire flush.

Finally, open a 3mm ring and connect the clasp to the end of a chain. Do the same for the clasp attachment with the other chain.

Your jewel is finished!

Beautiful creation!