2 closed rings 25mm
2 rings 6mm
2mm natural pearls
2 BO hammered nails
wire  nylon for weaving

pliers for jewelry creations
a beading needle

Weaving assembly

To start,  Cut a nylon thread of about 60cm then thread it through the eye of the needle.

Thread a bead then pass the needle under the closed ring.

Pass the needle through the inside of the ring before passing it back through the bead.

Pull firmly, keeping a starting thread of about 20cm. This will be stopped once the weaving is finished.

You will notice that the pearl is positioned at the outer edge of the circle.

Continue like this with the other beads until you fill them  completely outside the circle.

Be careful, mother-of-pearl pearls are fragile, remember to use a needle with a very fine eye. If you feel resistance when passing the needle through the pearl, do not force it.

Finally, gently iron the starting and ending threads and then make a discreet knot on the reverse side. Be careful not to break the beads during the last passage of thread.

Cut the wires flush.

Then open the 6mm rings and connect the weaving to the earrings.

And there you have it! Beautiful creation...