This creation is quite simple to make, you can adapt the number of natural stone beads to your taste. Follow the explanations below to faithfully reproduce this model.

To begin, cut a flexible brass wire of about 15cm. Do not take a wire too short to be comfortable in the assembly.

At one end of the wire, form a loop then thread the pendant into the loop. Be careful to look carefully at the visuals of the bracelet to place the pendants in the right direction.

Then wrap the wire around 2 times at the base of the loop created. Cut the excess wire flush. For a delicate and clean result, form a fairly thin and discreet loop.

Start stringing the beads. Thread a metal rondelle bead, a 4mm tourmaline, a metal bead, a tourmaline and again a metal bead. Then thread the Venus Hair Quartz bead before starting again in symmetry.

Attach the assembly to the other Ginkgo leaf pendant. Form a small, discreet loop using the round-nose pliers, then thread the pendant, paying attention to the direction (symmetry and front of the bracelet).

Now calculate the measurement of the bead/pendant string.

Measure your wrist then subtract the threading value from your measurement. Divide the result by 2. This gives you the value of the 2 chains to cut. Here we do not add an ease measurement because the clasp and the fastener will add a little weight to the bracelet. If you want a bracelet stuck on the wrist, adjust the measurements a little.

Then, once your 2 chains are adjusted, connect them to the pearl assembly with 3mm rings. Connect the chains to the rings located on the back of the pendants.

Finally, open a 3mm ring and connect the clasp to the end of a chain.Do the same for the extension chain with the other chain.

Your jewel is finished!

Beautiful creation!