24K gold plated metal beads
4mm faceted beads in natural stones
Linhasita 0.5mm wire
a 24K gold-plated stopper pearl

This jewel is very simple to make, to do this cut 2 Linhasita wires of approximately 25cm each.

Start threading the beads. You will see it is quite simple, we thread beads on the 2 wires separately, we assemble them with a bead threaded on the 2 wires at the same time...

Here is the order of threading how to make this pretty bunch.

Thread the 2 wires into a faceted bead, then thread a faceted bead on the right wire and 2 faceted beads on the left wire, join the wires by threading an oval bead.

Thread an oval bead onto the right wire and 2 faceted beads onto the left wire, join the threads by threading an oval bead.

On the right wire, thread a faceted bead, 2 natural beads and a faceted one.

On the left thread, thread a faceted pearl, a natural pearl and a faceted pearl.

Join the wires with an oval bead.

Now thread an oval bead onto the right wire and 2 faceted beads onto the left wire, join the threads by threading an oval bead.

Finally, thread a faceted bead on the right wire and 2 faceted beads on the left wire, join the wires by threading a faceted bead.

Tie a knot with the 2 threads at the ends of the beads to block them.

Now place the stopper bead. To do this, thread 2 threads on one side of the bead.

To place the other 2 in a crossing, use a very fine wire that you will fold in 2 and which will act as a large needle. Place it in the stopper bead, thread the 2 remaining wires into the loop then pull so that they pass without problem.

At the ends of the wires, thread a bead then make a knot with the 2 wires. Cut off the excess.

And there you have it! Beautiful achievement!