Pearls of  Miyuki 11/0 seed beads
Of the  3mm rings
Of  the twisted rod chain or other
Miyuki Dura-line yarn
A buoy clasp and extension chain
A needle
A pearl carpet

To start, cut a chain of about 38cm and cut it in the center to obtain 2 identical pieces. This will allow you to start weaving the central flower.

Cut a nylon thread of about 30cm and thread the needle.

Pass the needle through the first piece of chain and then thread 3 beads. Pass through the 2nd piece of chain and then thread 3 beads. Keep a starting thread of about 3cm to make the knot at the end.

Go back through the first chain, you will thus form a loop with the beads. Pull the thread well.

Then thread a yellow bead for the center of the flower. Insert the needle directly into the chain opposite and position the bead in the center of the others. (see photo 4)

Then we will go back through all the beads on the edge to consolidate the assembly.

Go back through the 3 beads (see photo 5) then through the chain (see photo 6).

Continue like this to go all the way around and return to the starting point, where the starting thread comes out. (see photo 8)

Finally, make a double knot by passing it through the loop twice. Make a second knot, tighten well and then cut flush.

Continue the assembly in this way for the other flowers... Here we left 3 twisted links between the flowers and made 7 flowers.

Finally, place the clasp and the extension chain at the ends with 3mm rings.

And there you have it! Beautiful creation!

Find all the supplies below...