of the  pearls  bohemian 6mm, 8mm, and 10mm
0.5mm linhasita wire
of the  8mm closed rings
A  screw clasp

To begin, cut a wire  line of about 60cm.

To connect the wire to the clasp, make a series of 3 knots with the end of the wire on an 8mm closed ring. Then cut the excess and burn the small end of wire to secure the knot.

Thread the beads starting with the 6mm beads, the 8mm and the 10mm in the center. Then start again in symmetry to finish the threading.

Thread the 8mm ring then make a series of 3 knots at the edge of the ring.

Be careful to keep fluidity between the beads, to do this before tying the knots, place the necklace in a curve. A necklace that is too rigid will not be comfortable to wear!

Finally, place the screw clasp to connect the closed rings.

And there you have it! Beautiful creation!