To begin, cut a nylon thread of approximately 80cm (allow a thread that is long enough as no connections will be possible during assembly).

Thread the needle and place 12 15/0 seed beads on the thread. Pass the needle back through the first bead to form a circle of beads.

Position the circle of pearls around the cabochon setting.

Now go back through all the beads in the circle to come out where the first thread comes out. Tighten your assembly well and then make a double knot.

Throughout the assembly, tighten your wire well, it must not be loose or the petals will be too soft.

Now start assembling the pearl petals.

Thread 9 2mm natural stone beads onto the wire.

Then go back through the bead in the circle and then the next one.

Repeat the previous step to make all the petals corresponding to the beads in the first circle.

Once all the pearl petals are finished, tie a double knot with the starter wire and then pass the wire through a few beads in the first bead circle. Trim flush. Repeat with the starter wire.

Finally, place a small dab of glue in the support and position the cabochon.

Your jewelry is finished!

Beautiful creation!