Simple pair Peyote weaving

Do you want to start peyote weaving? It's quite simple, with this tutorial discover the technique very useful basic to start and make bracelets. Later you can learn the odd weaving technique as well as increases and decreases. Here we go!

For this technique you need:
of the Miyuki delica beads a needle nylon thread

Step 1:

To begin, cut a piece of nylon thread and thread it onto a beading needle.

Then thread an even number of beads, leaving some thread at the start for finish weaving.

Step 2:

Then thread a new bead to start the second row.

Pass through the penultimate bead of the first row then thread a new bead.

Follow the diagram to see the wire path.

Step 3:
	As you go along, you simply place a bead in the hollows of the previous row.

Step 4:
Continue this way until you reach the desired length.

What if I need to extend my wire?

If your yarn is too short to complete the weaving, be sure to first keep about 15cm of wire. Then pass the wire through the previous beads following a path that can go diagonally to jump from one row to another.

Thread a new thread then go back through the previous rows diagonally to block the new thread and come out where you left off.

How to finish weaving?

In Peyote there is no knot to start or finish the weaving. To finish the weaving, go back through the previous beads and rows in several directions so that the thread blocks the beads.

Do the same with the starting wire.

Then to finish, you can either glue your weaving on a rigid cuff or on a leather strip or place a weaving clasp. To do this, you will have to make a new row to adapt it to the clasp.

And there you have it!