| This bracelet highlights a pretty stone with a raw appearance. It is composed of a chain worked and gilded with fine gold. An elegant creation that you can decline in earrings and even as a necklace.
| ||||
|---|---|---|---|---|
| For this achievement you need: | ||||
|
| ||||
| The assembly: | |||||
| To start, cut 2 pieces of chain. The first one is about 7cm and the second one is about 8.5cm. With this chain you can attach the carabiner directly to the links, which allows you to easily adjust your bracelet without adding an extension chain. Then cut a brass wire of about 20cm. Form a loop at one end of the wire, keeping about 1.5cm of wire. Thread the chain link into the loop and then wrap the small wire (1.5 cm) at the bottom of the loop for 2 turns. Cut the excess flush. Thread a Miyuki bead, a spinning top bead, the Quartz bead then, symmetrically, the spinning top and the Miyuki bead. Then form a loop 1mm from the last bead threaded then form a loop. Thread the other chain then wrap the wire around the edge of the loop for 2 turns. This allows for a very strong grip! Then to decorate the Quartz pearl, take a piece of brass wire, wrap one end of the wire around 1 turn between the spinning top pearl and the Quartz pearl. Cross the wire over the pearl then pass behind the other spinning top. Cross the wire over the pearl again then pass behind the spinning top. Go straight down towards the other spinning top, pass behind it then go straight back up towards the spinning top. Wrap the wire once then cut flush. You should get an X on the bead and 2 straight wires on the edges of the X. Finally, connect the carabiner to the shortest chain with a 4mm ring.
| |||||
| And there you have it! Beautiful creation! | |||||
Vous aimez les bijoux et les belles matières ?
Inscrivez-vous à notre Newsletter et restez informé de nos nouveautés, les derniers Tutoriels, les offres et promotions..
From the twisted link chain
