This creation is not very complicated, follow the explanations below to successfully assemble it.

To start, cut 2 pieces of chain, keeping 6 ball links. Then take the brass wire and form a coiled loop by placing one of the chains before coiling the wire. Cut the brass wire cleanly and if necessary, flatten the brass wire slightly to prevent it from snagging.

Thread the 3 Lapis Lazuli beads onto the brass wire and then form a symmetrically wrapped loop. Remember to place the other chain before wrapping the brass wire!

Your first row of the bracelet is now mounted!

Now, thread a crimp bead onto the silk thread, pass the needle through the last link of the chain and then pass it back through the crimp bead. Bring it back to the last link and flatten it gently. Make a double knot with the silk threads at the edge of the crimp bead and then cut the excess thread flush.

To secure the knot you can place a small dab of glue.

Now thread the mother-of-pearl beads, about 22 beads. Pass the Lapis Lazuli beads through the second hole and then continue threading the mother-of-pearl beads in symmetry.

Now thread a crimp bead, pass it through the last link of the chain and then pass it through the crimp bead again. Flatten it gently, making sure not to have too much tension between the beads. Your threading must remain flexible!

Tie a knot between the last mother-of-pearl bead and the crimp bead then secure with a small amount of glue.

Finally, connect the clasp and the extension chain (about 3cm) with 3mm rings.

Your jewel is finished!

Beautiful creation!