Mother of pearl pearls
0.7mm soft brass wire
Closed rings
A clasp
3mm rings
From the extension chain

To start, measure your wrist and adjust the size to your measurement. Here we are starting with a 16cm wrist, plus the extension chain.

Cut the brass wires to 16cm. Here we used 10.

Depending on the desired result, play with the number of brass wires.

Then insert the beads randomly on the wires, but remember to leave some without.

Form the loops at the ends of the wires. Make thin loops but not too small, they must be able to pass freely over the ring.

Open the loops created, then connect them to the closed rings. Check carefully that your loops are properly closed.

The wires can be crossed to play on the dynamics and volume of the bracelet, but be careful not to overdo it or you risk adding tension.

Lightly shape the wires to give them the shape of the bracelet.

Finally, connect the clasp and the extension chain to the closed rings with 3mm rings.

Find the assembly steps below.

And there you have it! Beautiful creation!