To begin, unwind your silk thread. Then thread the needle through the hole in the clasp and bring it back to the end of the silk thread.

Make the knots tight at the edge of the clasp ring. To secure the knots, make double knots, that is to say, you pass the thread twice through the loop before tightening the knot.

Using a thin rod, place a small amount of glue on the knots then cut the excess thread flush.

Now start threading the beads, alternating a mother-of-pearl bead and a small 2mm bead.

Continue this way until the desired length, taking into account the extension chain that will be added afterwards.

Finally, thread a 3cm piece of extension chain then tie the knots at the edge of the beads.

To make it easier to position the knot, you can insert a needle into the thread just at the edge of the chain. This will ensure that the knot is perfectly in place. Watch our video below.

Be careful not to tighten the row of pearls too much, it must remain flexible.

Your jewel is finished!

Beautiful creation!