Step 1:

To start, cut the chain to your size. Take the measurement tight to the wrist because the clasp and the donut bead will add the ease value.

Afterwards  mount the pearl donuts on the  chain, connect a small connector at one end with an oval ring, thread the pearl onto the connector then with another oval ring connect the clasp to the connector.

Step 2:

Mount the round natural stone pendants with a brass wire. This will create a more elaborate hanging.

To do this, cut a wire of about 15cm, thread the wire into the hole in the pendant, leaving about 2cm of wire out.

Twist  the small wire with the longer wire over 2 turns on the top of the pendant then cut the excess of the small wire flush.

With the long wire, form a loop on the top of the pendant and then wrap it around the pendant in a spiral. This will create a point of wire on the top of the pendant. Then go back up to the loop and cut off the excess wire.

Then mount the different elements on the chain with 4mm rings.

And there you have it! Beautiful creation!