Pearls of  Faceted Malachite 2mm
An oval connector pendant
Of  the nugget chain
A clasp  10mm carabiner
From the extension chain
From the thread of  brass 0.4mm
3mm rings

To begin, measure the size of your  wrist. Then remove 4cm corresponding to the size of the pendant then 1cm. Divide the measurement in 2, this gives you the length of the 2 chains to cut.

The value of the clasp and the connecting rings will add to the comfort value of the bracelet.

Cut an extension chain of about 3cm. This will allow you to adjust the bracelet to your wrist more easily.

Start editing:

To begin, cut  a flexible brass wire of about 6cm.

Thread the wire through the connector hole and then wrap the wire around the edge of the hole 2 times. Cut off the excess wire and flatten it with flat pliers if necessary.

Now thread 12 Malachite beads... Adjust the number to the size of the slot.

Then thread the wire through the hole in the connector and wrap it 2 turns between the bead and the edge of the slot.

Cut the excess wire flush.

Now you can slightly distort the pendant to give it a curved shape that will follow your wrist.

Finally, connect  the chains on each side of the pendant with 3mm rings.

At the ends place the clasp and the extension chain with 3mm rings.

And there you have it! Beautiful creation!