This creation is very easy to make,  for this we will mount the beads on 2 different threads which will cross all along the bracelet. You will see it is a very simple weaving technique which will position itself all along the assembly.

To start, cut 2 nylon threads of about 30cm each, then pass them through a crimp bead and then through the ring of the carabiner. Pass them through the crimp bead again and flatten it at the edge of the clasp. Thread a first bead onto the 2 threads at the same time then cut off the excess thread.

Now you can start weaving.

Now thread the beads onto the outer wires then group the wires with a central bead as shown in the image below.

Here for a nice rendering we added metal cube beads between the beads that go outwards. This also allows the beads to be better positioned.

Continue assembly until the correct length of the bracelet is reached.

Finally, thread a crimp bead and then a 4cm piece of extension chain then pass it back through the crimp bead. Pull on the thread to bring the crimp bead to the edge of the chain and to the edge of the last bead threaded.

Flatten the bead then cut the wire flush.

Your jewel is finished!

Beautiful creation!