To begin, equip yourself with flat nose pliers, wire cutters and round nose pliers. These tools will allow you to make pretty loops on the top of the beads.

Thread a pearl onto a nail, fold the nail 90° right at the edge of the pearl. This will allow the loop to be perfectly centered on the pearl but also to prevent the pearl from moving. Cut the nail while keeping about 8mm after the right angle. The size of the stem will have an influence on the size of the loop, be careful not to cut too short or conversely not to keep too much stem, you would have a loop that is too small or much too visible!

Now place the round-nose pliers at the end of the rod. Move the pliers back towards the center of the pearl. This will form the rod into a loop. For a successful loop, do this in several movements, replacing the pliers as needed.

Caution: Always handle the pliers gently. If you press too hard you risk scratching or marking the metal!

Continue assembling all the beads and use the video as a guide.

Then, connect the beads on the chain, leaving a free link between each bead.

Open the loops previously made in a spiral, place the loop on a link then close the loop in the opposite direction.

Be careful to place the beads all in the right direction on the links. To do this, each time place the chain flat, without twisting to visualize the direction of the ring.

If necessary, adjust the length of the chain and therefore the number of beads.

Finally, attach the clasp to one end of the chain.

Connect the extension chain to the other end with a jump ring.

Cut the extension chain if necessary and at the end, place the drop pendant with a ring.

Congratulations, your jewelry is finished!

Beautiful creation!