This creation is not very complicated to make, follow the explanations below to faithfully reproduce this model. Our video below shows you the essential steps.

Here I use the Brick Stitch weaving technique on a support for the first row of beads.

To begin, mount 26 gold Miyuki Délica beads around the edge of the closed ring.

Then, close the weave by going back through the first bead in the row, then the last one. Go back through the first one, then the second one. This will allow the beads to tighten well and your thread to block to begin the rest of the assembly.

Now, make the pearl petals. For a better understanding I will give a number to the pearls of the row made previously with as N°1 the pearl from which the thread comes out.

Thread an olive bohemian bead and a colored Miyuki Délica, pass through the bohemian bead then through bead No. 2. The Miyuki bead thus blocks the bohemian bead. Pull the thread well to tighten the bead at the edge.

Now go through bead No. 3. Thread a bohemian bead and a Miyuki bead, go through the bohemian bead again then through bead No. 4. Go through bead No. 5.

Continue in this way to position the 13 “petal” beads.

Make the colored border. To do this, go up a pearl petal and go back through the Miyuki pearl located at the top of the bohemian pearl. You are now positioned for the border.

Thread 8 colored Miyuki Délica beads then pass through the bead located at the end of the next bohemian bead.

Continue like this until you have completed the entire border. To consolidate the assembly, go back through the first beads of the border.

To mount the earring holder, pass through the hole in the holder and then through the bead below. Repeat the passage once to consolidate the assembly.

Finally, go back down the first row of beads and go through a few more beads.

Your jewel is finished!

Beautiful creation!