Pearls of  Faceted Malachite 2mm
Of  the nugget chain
A buoy clasp
From the extension chain
From the thread of  brass 0.4mm
3mm rings

To start, measure the size of your neck, leaving a little slack. This necklace should fall at the collarbones. Here we have made a 40cm choker. (Total size, clasp without the extension chain)

The extension chain will allow you to adjust the necklace more easily and adapt it to your different outfits. Please remember that the clasp must be included in your measurement.

Cut an extension chain of about 5cm. This will allow you to more easily adjust the necklace to your outfits depending on the necklines.

Start editing:

To start, cut 10  pieces of nugget chain, keeping 3 nuggets.

Take your brass wire and form a loop using the round nose pliers about 2cm from the end.

Thread a nugget link into the loop created and then wrap the wire around the edge of the loop for 2 turns. This blocks the loop and the chain and secures the assembly.

Then thread 8 Malachite beads...

Still using the round-nose pliers, form a small loop 1mm from the last bead then thread a new piece of nugget chain. To block the loop, wrap the wire between the loop and the last bead 2 times.

Cut the excess wire flush.

If your wire is sticking out a little, gently flatten it with flat pliers. This will prevent it from scratching yourself and snagging your clothes.

Continue in this way until you have made 9 pearl assemblies connected to the 10 pieces of nugget chains.

Finally, mount the buoy clasp on one side by opening its ring. And on the other side of the necklace mount the extension chain with a 3mm ring.

And there you have it! Beautiful creation!