6 Cowrie pendants
5mm rings
7mm cabochons
BO supports for 7mm cabochons
Glue

To begin, open a 5mm ring then insert 2 cowrie pendants. Be careful to position them in the same direction. Then close the ring correctly.

Continue the cascade, open a 5mm ring then connect a new cowrie shell to the previous cowrie shell.

For a harmonious result, make sure to place all the cowrie pendants in the same direction.

Then do the same for the 2nd earring, assembling the 3 other cowries in a cascade.

Now, place a small dab of glue in the BO support. Be careful not to put too much, place the drop of glue right in the center of the support, once the stone is in place, the glue will spread.

If you put too much glue, you can remove some with a small tip like a toothpick. It is better to remove it first to avoid it overflowing onto the support and the stone.

Place the cabochon in the holder and wait a few minutes before handling the earring.

Finally, carefully open the ring located on the BO support then connect the cowrie cascade.

And there you have it! Beautiful creation!