Domed earrings
Of the  Miyuki Delica beads 11/0
From the thread of  brass
A circle connector
Crystal Quartz Beads
4mm rings

To start, open a 4mm ring and thread 3 Miyuki beads. Place the ring around the pendant then close it properly using 2 flat pliers.

Repeat this step to place 6 rings per pendant, making sure to position them symmetrically with the rings of the pendant. This will give you small clusters of pearls.

Then cut a brass wire of about 15cm and bend it twice with round-nose pliers to form a small loop. Thread a Miyuki bead onto the wire then twist the wires to lock the bead in the loop.

Thread the Quartz bead onto the wires.

With one of the wires, form a loop on the top of the pearl, thread the pendant ring into the loop and then wrap the wire around the loop for 2 turns. This closes the loop and secures it. Cut the wire flush.

With the remaining thread,  fold it towards the loop located on the bottom of the Quartz bead, wrap it once between the loop and the bead then bring it back up, crossing the wire to form an X on the bead.

Finally, wrap the wire between the top of the pearl and the loop. Cut the wire flush.

Then open the BO ring and connect the pendant.

And there you have it! Beautiful creation!