This creation is quite simple to make, follow the explanations below to faithfully reproduce this model.

To begin, thread the bead onto the brass wire.

Please note that the hole in the mother-of-pearl beads is very fine and can be a little difficult to pass through. If the thread gets stuck, do not force it, take a needle and clear the hole. The brass wire is perfectly adapted to the hole size.

Form a loop on the top of the pearl and then insert the earring into the loop. Secure the loop by making 2 turns with the brass wire between the top of the pearl and the ring of the earring. Cut the excess brass wire flush.

For a beautiful result, try to make very discreet curls!

Now repeat this for the bottom of the bead, but this time insert the chain link into the loop before wrapping the wire between the bottom of the bead and the chain link. Trim the excess wire flush.

Before finalizing and cutting the chains, make the second earring in symmetry.

Once the 2 earrings are made, position them side by side to adjust the length of the chains.

As the pearls are unique and not the same size, we will correct with the length of the chains, so your jewel will be balanced.

Cut the chains to the length of your choice. Here we have chains of about 2.5cm.

Finally, open a 3mm ring and connect the set pendant to the bottom of the chain.

Do the same for the other earring in symmetry.

Your jewel is finished!

Beautiful creation!