For  To start, cut a brass wire of about 40cm then insert 4 pink beads and 4 yellow beads. Place the beads while keeping about 15cm of wire at the end.

Spread the last yellow bead aside and then pass the thread through the other strung beads. Pull on the thread to create a small row of beads blocked by the last yellow bead.

Repeat this operation to make 5 pearl pistils.

Be careful to place the pistils tightly, side by side on the brass wire. Then group the pistils into a small bouquet. Join the 2 ends of the brass wire.

Insert the pistils into the center of the flower bead.

Now mount the flower on the connector. To do this, insert the 2 ends of the brass wire into the hole in the connector and bring the flower firmly stuck onto the connector.

Then pass the wires through the other hole in the connector, thus returning to the front of the flower.

To secure it properly, pass the wires between 2 petals of the flower to return to the first hole of the connector.

Now wrap the wires between the flower and the connector around the starting wires. This will create a coiled loop. Do one more wrap and then cut the wires flush.

Now open a 4mm ring and connect the flower connector to the other identical connector.

Open a new ring and connect the previous assembly to the bottom of the earring.

Do the same for the other earring.

Your jewel is finished!

Beautiful creation!

Find all the supplies you need to make this piece of jewelry at the bottom of the page.