This creation is very easy to make, but will require some care to place the flower in its location. Follow our steps below for optimal assembly!

For  To start, cut a brass wire about 20cm long and form a coiled loop at the end. Try to make a small and discreet loop, this will be used to block the bead.

Then thread a 6mm pearl and the flower bud. Gently fit the pearl into the bud. To do this, you can spread the petals apart, being careful not to break them.

Now thread the flower onto the wire and bring all the elements back to the loop at the end of the wire.

Then thread the brass wire through the pendant ring. Wrap the brass wire 2 times around the bottom of the pendant ring.

Tighten the flower tightly against the pendant, there should be no play.

Now wrap the wire several times between the flower and the pendant, as if making a loop, then cut the wire flush.

Finally, open a 4mm ring and connect the pendant to the earring ring. Close the ring properly using 2 flat pliers.

Do the same for the other earring.

Your jewel is finished!

Beautiful creation!