To begin, you will need an 8mm mother-of-pearl bead, a flat head nail and a Lotus flower cup. The bead will fit into the heart of the petals and allow the cup to hold on the nail.

First thread the pearl onto the nail and then place the cup. Hold the cup gently without forcing it so as not to break it!

Then form a loop large enough to fit into the pendant.

Now open the loop made in a spiral with flat pliers and then position it inside the circle pendant. This step is a little tricky, hold the loop with the pliers, this will allow you to guide the nail through the hole in the pendant more easily.

Still using the flat pliers, close the loop, in the opposite direction, to secure the assembly. Make sure that the loop is properly closed and well aligned.

Now start assembling the beads located on the edge of the pendant.

Cut a brass wire of about 20cm and thread 2 Miyuki 11/0 beads, a 2mm mother-of-pearl bead and 2 Miyuki beads again.

Place the beads in the center of the wire then position the centered beads at the lower outer edge of the pendant.

Twist the wire around the pendant 2 times on each side of the beads. For a small wave effect, do not glue the beads to the pendant, leave a small space to create a curve of beads.

Continue like this on each side of the central beads. Tighten the wire tightly around the pendant.

7 small waves of pearls then wrap the wire around 3 turns tightly. Cut the excess flush with the last turn and on the back of the pendant.
Flatten the cut wire slightly with flat pliers, taking care not to damage the wire!

Finally, open a 5mm ring with 2 flat pliers then insert the pendant and the earring holder, making sure to position them in the right direction.

Close the ring, checking that it has returned to its axis and that there is no crack.

Your jewel is finished!

Beautiful creation!

Find all the supplies you need to make this piece of jewelry at the bottom of the page.