Jewelry Tutorial Mother-of-Pearl Earrings & wire wrapping

Video Tutorial

Fall for our new earrings made of mother-of-pearl beads decorated with a wrapped brass wire.

This is the opportunity to try the wrapping technique, this method consists of dressing a pearl with a brass wire, it is not very complicated to do and allows you to personalize your creations even more!

Find the video below to guide you through the assembly.

Beautiful achievement !

For this achievement you need:
2 stud earring holders gilded with 24K fine gold drop mother-of-pearl beads flower pendants Gilded with 24K fine gold 0.7mm soft brass wire Gilded with 24K fine gold

Tools to use:
pliers for jewelry creations
This jewel is not complicated to make. Follow the assembly in video below and the assembly instructions.

The assembly:

To start, cut a piece of brass wire about 15cm long.

At one end of the wire, form a simple loop with the round-nose pliers. Try to make a small, discreet loop.

Next, thread the flower pendant through the loop. Hold the loop with flat pliers and with another pair of pliers, wrap the wire around the edge of the loop 2 times. Cut off the excess wire and flatten the wire with flat pliers to prevent any ends from sticking out.

Thread the bead onto the wire and make a simple loop at the top of the bead.

Place the earring into the loop created and then hold the loop with pliers.

With the other hand, wrap the wire in a spiral, first just below the loop then down around the bead. To block the wire, make 2 turns at the bottom of the bead.

Cut off the excess flush and flatten the wire with pliers.

With this method you can make a clean spiral or increase the number of turns on the bead!