of the  6mm Heishi beads
pearls  metal and mother-of-pearl washers
a natural pearl
a clasp
wire  silk
crush beads

Measurement taking:

To start,  thread the assembly located in the center of the bracelet (mother-of-pearl washers, gold washers and the natural stone) then measure this threading. You can now undo it and keep it for the rest of the assembly.

Measure your wrist then remove the value of the previous beads. Also remove the value of the clasp then add 1cm for ease.

This gives you the length of the heishi beads. Now divide this measurement by 2.

Assembly :

Thread a few heishi beads and then the crimp bead. Pass through the clasp and then back through the crimp bead and heishi beads.

Bring your beads to the end of the wire and then crush the crimp bead. Cut the excess wire flush.

Then thread the remaining Heishi beads. (the last measurement obtained)

Continue threading with the central beads, metal washers, mother-of-pearl and the natural pearl.

Now thread the remaining Heishi beads to make symmetry.

Finally, thread the crimp bead and clasp. Thread through the crimp bead and then through a few heishi beads.

Pull on the thread, your bracelet will position itself in its final shape. Be careful to close the bracelet to finalize the assembly.

Keep the beads flexible and then crush the crimp bead.

Cut the excess wire flush.

Trick :  Before finishing the bracelet, always make sure to place it in its final shape, with the clasp closed. This way you won't run the risk of tightening the beads too much and getting a bracelet that's too rigid. Your threading must remain flexible!

And there you have it! Beautiful creation!