Linda bracelet

Fall for the bohemian spirit of this Miyuki pearl bracelet !

An ultra simple weave that is done directly on the support. The possibilities are endless, so you can give free rein to all your desires!

For this achievement you need:
Miyuki delica beads 11/0 A set of chevron connectors Miyuki Bugles beads a Cymbal pearl for cabochon a 4mm cabochon a lobster clasp from the extension chain 3mm rings Miyuki yarn and a beading needle

Overview:

Some explanations:

Start weaving from the central part.

To begin, cut a thread about an arm's length and then thread the needle.

This weaving is quite simple, it resembles the Wrap technique unlike that in this model we will pass through the holes of the rafters to fix each row.

Insert the needle, from below, into the bottom hole of the left chevron, then thread your beads (the number you want) then insert from below into the hole of the right chevron.

Keep a thread at the start of about 10cm to make the knot afterwards.

Pass the needle back through the bead row and then insert it into the chevron hole (the first one) from the top. So you come out below where the starting thread begins.

Move on to the second hole and repeat the previous operation. Thread the beads (the number of the previous row +1), stitch into the 2nd hole of the right chevron, from the bottom, then go back through the beads. Stitch into the hole of the left chevron from the top to come out on the wrong side.

After the 2nd row, make a double knot with the starting thread, on the wrong side, to block it then cut flush.

Continue like this with the following rows.

For the central row, place the Cymbal bead in place of the central bead. Once the bracelet is completely finished, you can glue the cabochon on it.

Be careful, on the central part, each row will have one more Miyuki bead than the previous one until the central row. Then you will decrease by one bead until the last row.

Continue assembling the bracelet using the same method.

On the side rows the number of beads will be the same for all rows.

Finally, measure the length of the bracelet then cut 4 pieces of chain to complete the length.

Connect the chains with 3mm rings then mount the clasp and the extension chain.

Tip: Make sure to always jump between the different holes, to go from one row to another, on the back of the bracelet.

And there you have it! Beautiful achievement!