Miyuki beads  Delica 11/0
of the  Peyote weaving hoops
Linhasita thread
Miyuki weaving thread

of the  beading needles

To begin, do the Odd Peyote weave starting from the center.

You will then go up one side then the other.

At each end, insert the hoops which will replace 2 beads.

Reinforce the grip of the hoops by going over the beads several times.

See the Weaving technique here: Peyote Odd

Follow the model opposite starting from the center. For a beautiful ombre effect, don't hesitate to mix matte and shiny colors.

You can also contrast the colors to make the design stand out.

Then make the borders...
To do this, block a new thread in the weaving and come out in the first bead.
Thread 3 beads then go back through the 2nd bead on the border.
Go back through the 1st bead and the 3 threaded beads before inserting the needle back into the 2nd bead.
This will help to strengthen the weaving.

Come out in the 3rd bead then thread 3 beads again...

Once the border is made, cut 3 polyester threads of approximately 50cm.

Fold them in half and then pass the ends through the ring of the hoop.

Thread the ends through the loop of thread to make a lark's head knot.

Do the same on the other side.

Then place the wires 2 by 2 and make a 3-strand braid.

Tie a knot at the end after adjusting the length for your wrist.

Finally, make the macramé sliding knot.

See the technique here: Macrame

And there you have it! Beautiful creation!