Step 1:

To start, cut a piece of brass wire about 20cm long.

Then cut 2 pieces of chain of about 15cm. Here we made a 40cm choker necklace. If you want a looser fit, feel free to extend the length of the chains.

At one end of the wire form a loop then insert the chain link. Then wrap the end of the wire at the bottom of the loop 2 times to create a rolled loop.

This allows for a clean and very solid assembly. Cut off the excess wire flush.

Start stringing the beads by alternating the donuts, metal beads and pendants. Follow the order of the beads in the photo below.

The size of the thread will be ideal on the neck, neither too long nor too short.

In the center place the enameled pendant then start again in symmetry...

Step 2:

Once your threading is complete, form a loop at the edge of the last bead then insert the other piece of chain.

Form a rolled loop as before. Be sure to make loops discreet enough for the finesse of assembly.

For a nice drape, distort the pearl thread to give it a curved shape that will follow your neck.

Then cut a 3cm piece of extension chain.

At the ends of the chains place the clasp with a ring on one side and the extension chain on the other.