Linhasita thread for macramé jewelry (size of your choice)
A rough stone
A  macrame rug

1 - To start, cut 3 pieces of wire of about 1m.
Adjust the size  to your liking. Here we made a necklace with a 0.35mm wire.
Then follow the diagram below.

2 - Make a knot in the center of the 3 cords.

3 - Separate the cords in a star shape to form 3 pairs.

4 - Tie a knot on each pair of cords.

5 - Be careful to place the knots at the same level. Tighten the knots well.

6 - Separate the wires and place them in pairs with the neighboring wires. Then make a knot.

7 - Continue the knots by going all the way around.

8 - Be sure to place the knots  at the same level for more regularity.

9 - Test if your stone is positioned well and check if the knots are well placed. If necessary, continue the knots.

10 - Once the correct size of the net is made, place the stone then tie a knot with all the cords to block the stone.

11 - Separate the wires into 2 sets of 3 wires then braid to the end.

12 - Tie a knot to secure the braids and cut off the excess thread.

And there you have it! Beautiful creation!