To start,  Mount the cushion beads on eye studs and form discreet and symmetrical loops.

Then connect the beads to the earring supports by opening the connecting ring located at the bottom of the earring support. Close it properly.

Now using 2 flat pliers, open a 5mm ring and insert the enameled mother-of-pearl pendant, the square pendant and the ring located at the bottom of the pearl. Close the ring correctly, still using the 2 flat pliers.

Do the same with the other earring.

Lightning bolt earrings  :

To start,  Cut 6 pieces of chains of different lengths. Here we made the loops asymmetrically, one is longer than the other to give contrast to the jewel worn.

We give you the lengths achieved but you can perfectly adapt them to your taste.

For a loop, a 2cm chain, a 3cm chain and a 4cm chain

For the other, a 1cm chain, a 1.5cm chain and a 2cm chain

Now connect the spikes at the bottom of the chains with the small rings  oval.

Finally, open a 4mm ring and insert the 3 chains, then connect the ring to the earring. Do the same for the remaining 3 chains.

Beautiful creation!